The Director of the Federal Register has approved, under 5 U.S.C. 552(a) and 1 CFR part 51, the incorporation by reference of the following publications. Incorporations by reference found within a regulation are effective upon the effective date of that regulation. For more information on incorporation by reference, see http://www.archives.gov/federal-register/cfr/ibr-locations.html .
U.S. EPA, Room M–1500, 401 M Street, SW., Washington, DC 20460
| Publication | CFR Reference |
|---|---|
|
Alaska: State of Alaska Requirements Applicable to OCS Sources, December 3, 2005; South Central Alaska Clean Air Authority Requirements Applicable to OCS Sources, August 21, 1992; Outer Continental Shelf Air Regulations Consistency Update for Alaska, February 8, 2007
|
Part 55.14
|
|
California: State of California Requirements Applicable to OCS Sources, February 2006; San Luis Obispo County Air Pollution Control District Requirements Applicable to OCS Sources, February 2000; Santa Barbara County Air Pollution Control District Requirements Applicable to OCS Sources, February 2006; South Coast Air Quality Management District Requirements Applicable to OCS Sources (Parts I, II, and III), February 2006; Ventura County Air Pollution Control District Requirements Applicable to OCS Sources, February 2006; Outer Continental Shelf Air Regulations; Consistency Update for California, October 23, 2007; Outer Continental Shelf Air Regulations Consistency Update for California, April 29, 2008
|
Section 55.14
Part 55, Appendix A |
|
Florida: State of Florida Requirements Applicable to OCS Sources, January 11, 1995
|
Part 55
|
|
North Carolina: State of North Carolina Air Pollution Control Requirements Applicable to OCS Sources, August 21, 1992
|
Part 55
|
Suite 104, 1827 Walden Office Square, Schaumburg, IL 60173
| Publication | CFR Reference |
|---|---|
|
AAMA 605–98, Voluntary Specification, Performance Requirements and Test Procedures for High Performance Organic Coatings on Aluminum Extrusions and Panels, 1998
|
59.401
|
100 Barr Harbor Drive, West Conshohocken, PA 19428–2959
| Publication | CFR Reference |
|---|---|
|
ASTM C1315–95, Standard Specification for Liquid Membrane-Forming Compounds Having Special Properties for Curing and Sealing Concrete
|
59.401
|
|
ASTM D523–89, Standard Test Method for Specular Gloss
|
59.104(e)
59.401 |
|
ASTM D 523-89, Standard Test Method for Specular Gloss, March 31, 1989 (Reapproved 1999)
|
59.508
59.515 |
|
ASTM D1613–96, Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
|
59.104(d)
|
|
ASTM D1640–83 (Reapproved 1989), Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings at Room Temperature
|
59.401
|
|
ASTM D3912–80 (Reapproved 1989), Standard Test Method for Chemical Resistance of Coatings Used in Light-Water Nuclear Power Plants
|
59.401
|
|
ASTM D4082–89, Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Light-Water Nuclear Power Plants
|
59.401
|
|
ASTM Method E220–86, Standard Method for Calibration of Thermocouples by Comparison Techniques
|
59.208(m)(4)
|
|
ASTM Method E380–93, Standard Practice for Use of the SI International System of Units
|
59.208(k)
|
9528 Telstar Avenue, El Monte CA 91731
| Publication | CFR Reference |
|---|---|
|
CARB Method 310, Determination of Volatile Organic Compounds (VOC) in Consumer Products and Reactive Organic Compounds in Aerosol Coating Products, May 5, 2005
|
59.508
59.515 |
421865 Copley Drive, Diamond Bar CA 91765; (909) 396-2000; 1-(800) CUT-SMOG (288-7664)
| Publication | CFR Reference |
|---|---|
|
SCAQMD Method 25.1, March 1989, Determination of Total Gaseous Non-Methane Organic Emissions as Carbon (amended February 26, 1991)
|
59.208(g)(2)
59.208(j)(3) |
|
SCAQMD Method 318-95, Determination of Weight Percent Elemental Metal in Coatings by X-Ray Diffraction, July, 1996
|
59.508
59.515 |