e-CFR banner

Home
gpo.gov
govinfo.gov

e-CFR Navigation Aids

Browse

Simple Search

Advanced Search

 — Boolean

 — Proximity

 

Search History

Search Tips

Corrections

Latest Updates

User Info

FAQs

Agency List

Incorporation By Reference

eCFR logo

Related Resources

 

Electronic Code of Federal Regulations

e-CFR data is current as of December 4, 2019

Title 40Chapter ISubchapter CPart 63Subpart WWWW → Appendix


Title 40: Protection of Environment
PART 63—NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS FOR SOURCE CATEGORIES (CONTINUED)
Subpart WWWW—National Emissions Standards for Hazardous Air Pollutants: Reinforced Plastic Composites Production


Table 7 to Subpart WWWW of Part 63—Options Allowing Use of the Same Resin Across Different Operations That Use the Same Resin Type

As specified in §63.5810(d), when electing to use the same resin(s) for multiple resin application methods, you may use any resin(s) with an organic HAP content less than or equal to the values shown in the following table, or any combination of resins whose weighted average organic HAP content based on a 12-month rolling average is less than or equal to the values shown the following table:

If your facility has the following resin type and application method .  .  .The highest resin weight is*   *   * percent organic HAP content, or weighted average weight percent organic HAP content, you can use for .  .  .is .  .  .
1. CR/HS resins, centrifugal casting1 2a. CR/HS mechanical348.0
   b. CR/HS filament application48.0
   c. CR/HS manual48.0
2. CR/HS resins, nonatomized mechanicala. CR/HS filament application46.4
   b. CR/HS manual46.4
3. CR/HS resins, filament applicationCR/HS manual42.0
4. non-CR/HS resins, filament applicationa. non-CR/HS mechanical345.0
   b. non-CR/HS manual45.0
   c. non-CR/HS centrifugal casting1 245.0
5. non-CR/HS resins, nonatomized mechanicala. non-CR/HS manual38.5
   b. non-CR/HS centrifugal casting1 238.5
6. non-CR/HS resins, centrifugal casting1 2non-CR/HS manual37.5
7. tooling resins, nonatomized mechanicaltooling manual91.4
8. tooling resins, manualtooling atomized mechanical45.9

1If the centrifugal casting operation blows heated air through the molds, then 95 percent capture and control must be used if the facility wishes to use this compliance option.

2If the centrifugal casting molds are not vented, the facility may treat the centrifugal casting operations as if they were vented if they wish to use this compliance option.

3Nonatomized mechanical application must be used.

[70 FR 50133, Aug. 25, 2005]

Need assistance?